Waterblasting Technologies

Non-Destructive Runway Surface Rubber and Road Marking Removal Systems

Waterblasting Technologies, Inc. manufactures the Stripe Hog Waterblasting System and Smart Vac Vacuum Systems which are used to remove rubber deposits from touchdown zones on runways and all types of traffic markings from asphalt and concrete runways and roadways.

The Stripe Hog Waterblasting System quickly and completely removes all types of durable traffic markings from asphalt and concrete surfaces with the least amount of negative impact to the surface. The Stripe Hog does its work using many needle sharp 40,000 psi water jets and a powerful vacuum recovery system, called the Smart Vac that leaves the road or runway clean and almost dry. The resulting debris is quickly dehydrated using a patented process, so that the debris can then be dumped in a dried state in one big clump that easily falls from the tank making the jobsite cleanup easy and complete.more

Airport and Runway Solutions

Waterblasting Technologies is the world-leading manufacturer of waterblasting equipment for runway rubber removal. The world-renowned Stripe Hog waterblasting system is operating in 35 countries on six continents, and has more units working around the world than its top four competitors combined. Customers describe the operating system as being innovative, efficient, productive, versatile, profitable and dependable. All units operate at 40,000 psi (2750 bar) and, dependent upon the model, are capable for removal widths from 6-72 inches (15.2-182.9 cm).

With six chassis-mounted systems, two skid-mounted systems, a full line of attachment options and production capabilities from 6-12 gallon a minute (22.7-45.4 liters a minute), there's no need for a 'one size fits all' machine.

Runway Rubber Removal

Every time an airplane lands it leaves a small amount of rubber on the runway surface. This rubber melts to the surface, working its way into the grooves cut into the runway for water drainage and additional friction. Overtime, this rubber builds up on the runway surface causing it to loose its friction characteristics, becoming slippery and eventually unsafe for aircrafts to land on. This rubber also starts obscuring runway paint markings creating additional safety concerns.

Stripe Hogs quickly and effectively removes runway rubber deposits, returning the necessary friction characteristics to the surface without adversely affecting the surface profile.

Because Stripe Hogs only use water there are messy caustic chemicals to clean up leaving the clean and relatively dry allowing the runway to be used almost immediately after cleaning.

Stripe Hog SH8000 Runway Paint Removal

Marking Removal

The Stripe Hog quickly and completely removes all types of durable markings from asphalt and concrete applications while not adversely affecting surfaces even if that surface is grooved or very porous.

The complete removal of all forms of durable traffic markings from all surfaces has never been as quick, clean and cost efficient. And perhaps best of all, very little to no confusing mark left behind, NO re-surfacing, and NO secondary clean-up or drying necessary.Thermoplastic, waterborne paints, epoxy paints, rubberized paints, even temporary and permanent foil backed or waffle tapes do not stand a chance against the 40,000 psi (2750 bar), Stripe Hog!

The very best in high-pressure waterblasting and simultaneous vacuum recovery now exist on a single, fully self-contained, mobile unit.

Airport Paint Rejuvenation

Paint cleaning & rejuvenation isn't just for roads and bridges, this process can also be used at airports as well, rejuvenating runway center lines quickly and cost effectively. Thanks to the Stripe Hog, roads and runways alike will have a higher degree of safety with little to no closure time.

The Stripe Hog Waterblasting System can remove markings, rubber, contaminates, algae, etc. from markings restoring them to desired reflectivity levels. This cleaning and rejuvenation process will increase the longevity of paint markings, reducing the cost and frequency of re-painting, while at the same time instilling a greater level of safety at your airport.

About Waterblasting Technologies

Waterblasting Technologies, founded in 1988 by its current president and CEO James P Crocker, manufactures the Stripe Hog Waterblasting System and is the world leader in marking removal, rubber removal, surface preparation and pavement cleaning. The Stripe Hog removes all types of pavement markings from roads and runways, and rubber deposits left from aircraft landings. The Stripe Hog has been sold in over 43 countries around the world, with more units operating than our five closest competitors combined.less

Videos

View all Videos

Articles

View all Articles
View all Galleries

Categories

View all Categories

Documents

View all Documents

You are about to contact Waterblasting Technologies. Please fill in the form below and your enquiry will be sent directly to the supplier's email address.

Fields marked with are required

Enquiry sent

Your enquiry has been sent successfully to Waterblasting Technologies. You will be contacted by one of their representatives shortly.

Would you like to receive enquiries like the one you have just sent?

Add your company for free below!

Thank you for using Copybook. Click here to send another enquiry.

Error

Oops... An error occured during your enquiry submission.

Please try again later or contact the system administrator at admin@copybook.com.

Click here to re-send the enquiry.

Waterblasting Technologies
3170 South East Slater Street
34997, Stuart
USA

page up